Description
A.Y. McDonald Adapter, Fitting/Connector Type: Adapter, 1 x 3/4 in Nominal, Ranger Compression x MNPT, 150 psig, Brass, Domestic
Features:
- Meet and exceeds AWWA C80014, which requires fittings to be suitable for a water pressure of 150 psig
- Withstands the same pressures as the tubing, but must not be used with pressures exceeding 300 psig
- Double leed thread allows for compression nut to be assembled in half the time of a standard compression nut and eliminates the possibility of assembling an incompatible nut to these fittings
- Designed for underground and above ground cold potable water systems
- Large wrench flats for tightening to torque
- Tighten to torque required noted on installation instructions
- Provides pull-out strength equal to other compression fittings
Standards/Approval:
- AWWA C80014
- NSF/ANSI/CAN 61-2018
- NSF/ANSI 372-2016
- UNS C89833
- PROP65: It is unlawful in CALIFORNIA, VERMONT, MARYLAND, LOUISIANA and the UNITED STATES OF AMERICA to use any product in the installation or repair of any public water system or any plumbing in a facility or system that provides water for human consumption if the wetted surface area of the product has a weighted average lead content greater than 0.25%. This prohibition does not extend to service saddles used in California, Louisiana or under USA Public Law 111-380. This product can expose you to chemicals including lead, which is known to the State of CALIFORNIA to cause cancer and birth defects or other reproductive harm. For more information go to: www.P65Warnings.ca.gov
Warranty:
Limited
