Description
O-Z/Gedney Cable Sealing Assembly, Type WSK Watertight, For Use With: Conduit, Cable, Pipe or Tubing, Wall Mounting, Ductile/Malleable Iron, Epoxy Zinc Coated
Features:
- Provide a watertight blockage between poured concrete and the fitting body
- The watertight blockage is accomplished by specially designed fins cast on the outside of the fitting body, which permit the concrete, when it cures, to shrink around these fins
- Provide a pressure seal between the fitting body and the outside diameter of any round casing penetrating a wall, floor or ceiling
- Pressure sealing is based on an engineering principle that solid rubber like materials are incompressible
- Type FSK and WSK thru wall sealing fittings are used where a single casing penetrates the fitting
- The FSC and WSC thru wall sealing fittings are used where multiple casings penetrate through one fitting
- The type FSK and type FSC fittings are used for most sealing applications
- They consist of a body and sealing assembly located on the inside of the structure and an oversize sleeve which extends from the fitting to the outside of the structure wall
- The WSK and the WSC fittings are the same as the type FSK and FSC fittings except that they have a body and sealing assembly on both sides of the oversize sleeve
- This provides a pressure seal on both sides of the wall, the type WSK and WSC fittings can
- Another purpose for the type WSK and WSC fitting is to keep the round casing in the center of the fitting and not have it deflect in the oversize sleeve in the event of earth movement in the back fill
- Sealing grommets have an expected life in excess of 20 years
- The steel pressure ring is closely sized to fitting the inside diameter and outside diameter of the casing
- It has a PVC coating that provides an insulation between the sealing assembly and the casing to provide cathodic protection by eliminating stray
- Oversize sleeves have a marker strip to facilitate field cutting of sleeves to accommodate walls or floors of varying thicknesses
- Blank fittings are intended for use as abandonment plugs and for sealing openings reserved for future use
- O-Z/Gedney will not be responsible for any device that has been modified in the field
- Sealing assembly consists of the following parts - pressure clamp, hex head cap screws, pressure rings and sealing grommet
Applications:
For conduit, pipe or tubing enters a building through the concrete foundation below grade or ground water level or where it is necessary to seal around a conduit, pipe or tubing
Standards/Approval:
- Buy American Act Compliant
- NEC Certified
- CEC Compliant
