Description
LEESON® AC Gearmotor, Continuous Duty Parallel Shaft, Series: PE350, 230/460 VAC, 2/1/1.6/0.8 A Full Load Amperage, 0.33 hp, 60 Hz Frequency, 3 ph, 173/144 rpm Maximum, 3/4 in Shaft Diameter, 3/8 in Shaft Length, Reconnect Rotation, 109 in-lb Torque, 10:1 Gear Ratio, PE352-42 Gear, Needle Bearing, 300 lb Overhung Load, Class F4 Insulation, Totally Enclosed Fan Cooled Enclosure, Die Cast Aluminum Housing Material, 13.81 in L x 6 in W x 5.57 in H Dimensions
Features:
- Precision machined gearing, hardened for maximum load capability
- All gearing designed and rated to AGMA class 9 standards and to withstand momentary shock overload of 200%
- Oversized output bearings for greater overhung load capacity and long life
- High carbon alloy output shaft provides maximum strength and rigidity
- All needle bearing journals are precision ground after heat treating to provide maximum fit and finish
- Gears and bearings are splash lubricated with permanent, heavy duty gear oil
- Run capacitor supplied at no additional cost for single phase designs
- Full stainless steel exterior promotes resistance to water and chemical corrosion
- Double sealed bearings extend the lifetime of the motor by combating early signs of bearing failure
- Stainless steel output shaft seals protect against external contaminants
- Insulation systems deliver superior protection against voltage spikes
- All rated for 60/50 Hz operation except hi-torque single-phase which are 60 Hz only
- Heavy duty industrial oil seals keep lubricant in and dirt out, Gears and bearings are splash lubricated with permanent, heavy duty gear oil, Run capacitor supplied at no additional cost for single phase designs
- Three phase and hi-torque single phase models include conduit box, other single phase models do not
- Overhung load capacities shown are at center of output shaft, Optional conduit box available
Applications:
For mounting at any angle, but motor below the reducer should be avoided to prevent leakage of lubricant into the motor should the motor shaft seal fail
Standards/Approval:
