Description
Dixon® External Swage Ferrule, Long, Series: Holedall™, Fitting/Connector Type: Ferrule, 4 in ID x 4-30/64 to 4-39/64 in OD Nominal, Hose, Carbon Steel, Domestic
Features:
- The coupling system requires no bolts and results in a clean coupling with no protrusions
- The holed all coupling provides long lasting efficiency and safety
- Style FL ferrules are extra long and are used with all long style external swage stems - TML, TGL and TPL styles
- The selection of ferrules is very important to achieve the proper coupling-to-hose assembly
- Dixon® holed all stems and ferrules are specifically designed to be used together as a coupling system
- Due to differences in dimensions and tolerances, for safety reasons, do not use other manufacturer's stems or ferrules with Dixon® holed all products
- Do not use a wrench or vice on ferrule
- Holed all couplings, regardless of coupling style, are never to be used for steam service at any pressure
- Holed all fittings are not to be used with cable reinforced high pressure hose, 4 or 6 braid wire hydraulic hose or any other service not listed in the recommendations
- Externally swaged holed all couplings, to perform satisfactorily, must be applied properly in accordance with Dixons assembly procedures, using correct die and ferrule for that particular hose end OD
- Dixon® die and ferrule recommendation guide is to be used to select correct dies and ferrules
- Hose service working pressure (including surges and spikes) is never to exceed the maximum recommended working pressure for the fitting
- The assembly's (hose + coupling) maximum working pressure is the lesser of the hose rated working pressure or the coupling rated working pressure
- Media being transported through the hose should be compatible with the stem material
- Compatibility of ferrule material with the environment in which it will be used is recommended
- Do not use in connection with drinking water
- Wash hands after handling
Applications:
For use where additional retention is required due to higher working pressures or end pull, on most one and two wire braid reinforced hoses and fiber reinforced (braided or spiraled) with or without helical wire such as: oil and suction discharge hose, barge and dock loading and unloading hose as well as LP gas hose, anhydrous ammonia hose, acid chemical hose and air and water hose
