Description
EATON Soft Starter, Non-Combination, Series: S611, 480 V, 65 A, 47/63 Hz, 50 hp Motor, 108/132 VAC Coil, 3 Pole, 0.5 to 180 s Timing, 3 ph, Lug, Solid State Overload Relay, 32.5 to 65 A Full Load, -20 to 50 deg C Operating, 7.64 x 11.58 x 19.45 in
Features:
- User interface module (UI) provides an intuitive, easy to use human interface with powerful configuration capabilities to maximize system performance
- Door or device mounted enables users to safely configure, commission, monitor and troubleshoot the system at the electrical panel without opening the enclosure door
- System operating parameters can be monitored enterprise wide through a communications network
- Increase uptime by providing data for process management and preventive diagnostics
- Run bypass mode greatly reduces internal heating created by the greater power dissipation in the SCRs
- Bypass contactors directly connect the motor to the line and improves system efficiency by reducing internal power losses
- Internal solid state overload protection provides accurate current measurement and trip settings
- Internal run bypass contactors and overload protection eliminate the need for additional devices, reducing enclosure sizes minimizing installation and wiring time and reducing overall assembly size and cost
- Wide range of overload FLA settings and a selectable trip class Offers users the flexibility to fine tune the starter to match specific application requirements
- Variable ramp times and torque control settings provide unlimited starting configurations, allowing for maximum application flexibility
- Kick start feature enables soft starting of high friction loads
- Soft stop control for applications where an abrupt stop of the load is not acceptable
- Pump control option with sophisticated pump algorithms on both starting and stopping that minimize the pressure surges that cause water hammer
- Six SCRs control all three motor phases providing smooth acceleration and deceleration performance
- Soft acceleration and deceleration reduces wear on belts, gears, chains, clutches, shafts and bearings
- Reduce the peak inrush current's stress on the power system
- Minimize peak starting torque to diminish mechanical system wear and damage
Applications:
For controlling the acceleration and deceleration of 3-ph motors, electrical assemblies, panels and OEM's applications
Standards/Approval:
- CSA File No. 3211-06
- IEC 60947-4-2
- NEC Certified
- UL Listed
