Description
Anvil® Pipe Roll Stand, Adjustable, Series: FIG 274, 4 to 6 in Pipe, 950 lb, Cast Iron, Plain, 8-1/4 in L x 5-3/4 in W Base Plate, 400 deg F, Domestic
Features:
- Non conductive pipe rollers - prevent the passing of current from pipeline to structure.
- For support of pipe lines where longitudinal movement due to expansion and contraction may occur and where vertical and lateral adjustment during installation may be required
- Non conductive pipe rollers - prevent the passing of current from pipeline to structure
- Corrosion resistant - for protection against severe weather conditions, moderate corrosive conditions such as marine atmospheres and weather resistant to ultra-violet radiation
- Low coefficient of friction between pipe and resilient coated pipe roller
- 2 through 42 in pipe size
- Installation: base plate is provided with two holes for anchorage to floor, pier, structural support and similar constructions, as well as to welded steel brackets (Fig 195 and Fig 199), adjustable pipe roll stand without base plate (Fig 275) can be used for supporting tunnel piping etc, by resting ends of adjusting screws on structural steel angles, channels, etc
- Adjustment: vertical adjustment is obtained by use of the four adjusting screws located on corners of stand, lateral adjustment is secured by stand sliding on each of adjusting screws
- Cast iron base plate, stand roll, steel adjusting screws
Standards/Approval:
- ANSI/MSS SP-69/SP-58 (Type 46)
- Federal Specification A-A-1192A (Type 46)/WW-H-171-E (Type 47)
