* Quantity discounts may be available. Call 800-918-8939.
Alternatively, you may e-mail info@kscdirect.com for service.

Shop our Bargain Bin for closeout specials.

GEN'L WIRE MR-B MINI-ROOTER MACHINE

General Wire MR-B Mini-Rooter Basic Unit with 75' x 3/8" Cable

The General Wire MR-B Mini-Rooter Includes:
The Mini-Rooter Basic Unit Including MR-200 Drum, 1/3 hp Motor with Reverse Switch, 10 ft. Power Cord, Ground Fault Interrupter, Water-Proof Air Foot Switch, Leather Gloves, 75' x 3/8" cable (75EM2), and MRCS Cutter Set.

General Wire MR-B Mini-Rooter Features:
With a 1/3 hp motor, the Mini-Rooter clears lines from roof-top to basement, including kitchen, bath and laundry drains.

This inexpensive, light weight machine has lots of time-saving features. For instance, you can remove the drum in seconds for more portability or switch to a different diameter cable--with no mess and no lost time. A distributor tube inside the drum allows you to feed cable in and out without chucking and releasing the cable every few feet - so you finish quicker. An optional power cable feed gives you better feeding and retracting control.

For small drain work, you can order your Mini-Rooter with a "J" Drum or a Dual Drum for handling smaller, more flexible cables. An optional Mini-Rooter dolly lets you roll the machine to and from the job on 8" semi-pneumatic wheels.

Some Mini-Rooter safety features: A foot pedal that uses air pressure to start and stop the machine, with no electrical wiring between pedal and motor, a ground fault circuit interrupter, and a high impact plastic guard covering the motor pulley.

General Wire MR-B Mini-Rooter Specifications:
• Weight: 37 lbs. (17 kg) without cable.
• Dimensions: 18" deep x 12" wide x 19" high (45 cm x 30 cm x 46 cm).
• Drum: Capacity of 75 ft. of 3/8" or 1/2" Flexicore wire rope center cable. Integral distributor tube. Oilite bronze and ball thrust bearings.
• Motor: 1/3 hp, with forward-off-reverse switch, spring- loaded mounting for proper belt tension.
• Load Speed: 165 rpm.
• Belt Guard: High impact plastic.
• Foot Pedal: Leaves operator's hands free to control cable. Uses air pressure, so there's no electrical contact between pedal and motor.
• Power Cord: 10 ft. 3 wire vinyl covered with molded plug. In-line ground fault circuit interrupter.
• Leather Gloves: With reinforced palm for hand protection and proper slippage when guiding cable.